Grizzly Heavy Duty Mill/ G1006 - Manual (Page 35)

BdYZa<&%%+$<&%%, B[\#H^cXZ.$%.
"(("
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
;dg dei^bjb eZg[dgbVcXZ [gdb ndjg bVX]^cZ!
[daadli]^hbV^ciZcVcXZhX]ZYjaZVcYgZ[ZgidVcn
heZX^[^X^chigjXi^dch\^kZc^ci]^hhZXi^dc#
Daily Check:
•
Loose mounting bolts.
• Damaged cutting tools.
• Worn or damaged wires.
• Any other unsafe condition.
• Clean/Vacuum chip buildup from machine.
Monthly Check:
•
V-belt tension, damage, or wear.
Schedule
BZiVa X]^eh aZ[i dc i]Z bVX]^cZ i]Vi ]VkZ WZZc
hdV`ZYl^i]lViZg"WVhZYXddaVcil^aa^ck^iZdm^YV"
i^dc VcY V \jbbn gZh^YjZ Wj^aY"je VgdjcY i]Z
bdk^c\ eVgih# JhZ V Wgjh] VcY h]de kVXjjb id
gZbdkZ X]^eh VcY YZWg^h [gdb i]Z ldg`^c\ hjg"
[VXZhd[i]Zb^aa#CZkZgWadli]Zb^aad[[l^i]Xdb"
egZhhZYV^g!Vhi]^hl^aa[dgXZbZiVaX]^ehYZZe^cid
i]ZbZX]Vc^hbhVcYbVnXVjhZ^c_jgnidndjghZa[
dgWnhiVcYZgh#
GZbdkZ Vcn gjhi Wj^aY"je [gdb jceV^ciZY XVhi
^gdc hjg[VXZh d[ ndjg b^aa VcY igZVi l^i] V cdc"
hiV^c^c\ajWg^XVciV[iZgXaZVc^c\#
@ZZe jceV^ciZY hjg[VXZh gjhi"[gZZ l^i] gZ\jaVg
Veea^XVi^dchd[egdYjXiha^`Z<.+œ<jcIgZVibZci!
HA>E>Iœ!dg7dZh]^ZaYœI".#
Cleaning and
Protecting
The gibs are pre-adjusted at the factory and will
not need further adjustment by you until after
extended use. If movement seems too tight
at first, make sure that all rust preventative is
removed from the ways, lubricate them with oil,
and work the table back and forth several times
to loosen it up.
The gibs are adjusted by turning the large slot-
ted screw heads in the front and right side of
the table base until you feel a slight drag when
you turn the handwheels. The screw at the front
of the machine affects movement from front to
back. The screw under the right side of the table
affects longitudinal movement. You can loosen
the screws if your table movement seems exces-
sively stiff.
Gibs