Gefen EXT-DP-441 - Manual (Page 28)

25
TELNET CONTROL
5. Use the #sipadd command to set the IP address for the Control System.
Check with a network administrator to obtain an available address, if
necessary. DHCP is not supported by this Switcher.
#sipadd 192.168.2.234
New IP set to: 192.168.2.234
After setting the IP address, power-cycle the Switcher for the changes to
take effect.
6 Specify the IP of the Control System in the Telnet client. In this example, the
IP address is set to 192.168.2.234. Once connected to the Control System,
the Telnet client will display a screen similar to the following:
----------- Welcome to DP441 Telnet Server ----------
You are user number 1 of 3 allowed.
You will be disconnected after 10 minutes of inactivity.
Login: Admin
Password: Admin
Type Cmd:
By default, the user name and password options are enabled by use of
the #use_telnet_pass command (see page 20). Once this command
is enabled, the Switcher will prompt for both the user name and password.
The password cannot be disabled from the login process. Once logged in,
the Type Cmd prompt will be displayed.
The Telnet interface uses the same commands and syntax that are used with
RS-232 control. See the command list, starting on page 15.
IMPORTANT: All IP confi guration changes will require the
Switcher to be power-cycled.