GE 25982xx3 - Manual (Page 29)

9
5. Press the memory button or mem button again to save your selection. The display
shows ENTER TEL NUMBER.
NOTE: If you make a mistake, press the delete button on the base
or chan/delete on the handset to backspace and erase the wrong
character(s) or number(s).
6. Use the touch-tone pad to enter the area code followed by the telephone number
(up to 4 digits, including pauses) and press the memory button or mem button again
to save your selection. You will hear a confirmation tone.
7. To enter another name and number in a different memory location, return to step 1
and repeat the process.
Storing a Redial Number
1. Make sure the phone is OFF (not in TALK mode).
. Repeat step 1 through 6 in Storing a Name and Number in Memory.
3. Press redial to display the redial number and name.
4. Press memory or mem button again to confirm.
NOTE : If the number you want to redial has more than 24 digits,
the telephone number cannot be stored in memory.
Inserting a Pause in the Dialing Sequence
Press the #pause button on the touch-tone pad to insert a delay in the dialing
sequence of a stored telephone number when a pause is needed to wait for a dial tone
(for example, after you dial 9 for an outside line, or wait for a computer access tone.)
Each pause counts as 1 digit in the dialing sequence.
Reviewing, Changing or Deleting Stored
Names/Numbers
To Review: Press mem button on the handset or memory button on base, then press
the caller id (9 or :) button (on base) or the CALLER ID-VOLUME (6 or 5) button (on
cordless handset) to scroll through the stored numbers. Or press the memory location
number.
To Change: Follow the steps under Storing a Name and Number in Memory except
replace the stored name or number with the new information.