GE 25982xx3 - Manual (Page 41)

41
UNAVAILABLE Indicates the handset is out of range. Or an additional handset
is in use. Or there has been a base power failure, in which case
you must place all handsets on the main base cradle for 0
seconds to re-establish link with the base.
UNKNOWN NAME/ The incoming call is from an area not serviced by Caller ID or
CALLER/NUMBER the information was not sent.
WAITING HANDSET Prompt telling you to enter registration mode of handset.
REGISTRATION
Handset Sound Signals
Signal Meaning
A long warbling tone (with ringer on) Signals an incoming call
Three short beeps Page signal
One short beep (every 7 seconds) Low battery warning
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the problem
might be your wiring or local service.
• The cordless handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack installed correctly.
• Did the handset beep when you pressed the TALK/CALL BACK or SPEAKER
button? The battery may need to be charged.
• Place handset in charge cradle for at least 0 seconds.
Dial tone is OK, but can’t dial out
• Make sure the TONE/PULSE setting on the base is set to the type of phone
service you are subscribed to.