Grizzly H7826 - Manual (Page 13)

Model h7826 (Mfg. since 2/07) -11 -
this nailer may accidentally fire if
you work on it without disconnecting
it from the air supply. always discon-
nect air from nailer whenever clearing
a jammed nail!
a jammed nail must be cleared before
using the nailer again.
to clear a jammed nail from the dis-
charge area:
1. disConnECt nailEr FroM thE
air supply!
2. pull the magazine loader all the way
back and remove the nail stick.
3. the jammed nail should now be vis-
ible; use needle nose pliers to remove
it from the discharge area.
—if the nail cannot be removed, con-
tinue to step 4.
—Continue to step 6, when the
jammed nail is removed.
clearing Jammed
nails
4. remove the cap screws shown in
figure 11 that secure the magazine.
6. load a new nail stick that only contains
clean, undamaged nails. do not use
dirty or damaged nails!
figure 11. Cap screws securing the
magazine.
5. remove the jammed nail (figure 12)
with a pair of needle nose pliers, then
replace the magazine.
figure 12. Jammed nail in discharge area.