GE 60-883-95R - Manual (Page 11)

Programming 6
Entering Program Mode
1. Open the panel cover by lifting on the tab at the
top of the panel.
2. Enter Utility Access Code 1 or 2 using the num-
bered keys.
The panel is now in program mode. Follow the pro-
gramming arrows on the panel overlay. The system
prompts you through programming steps with beeps
and voice messages.
Setting the Clock
Note
Do not remove panel power
while in program mode. Pro-
gramming changes are
saved only when exiting pro-
gram mode (closing the
cover).
¾ To set the clock:
1. Press Clock Set from the Start Menu. (The system will announce the programmed time and
say “To change, press Hours and Minutes, then press Done.”)
Note
If 6 seconds passes without a key press the panel will announce the time and say “Time is x:xx A . M ./
P . M ., press hours and minutes, then press done or press cancel to quit.”
2. Press the Hours + and - buttons and listen to the voice prompts. Stop when panel voice
announces the correct hour.
3. Press the Minutes + and - buttons and listen to the voice prompts. Stop when the panel
announces the correct minutes.
4. Press Done. The panel announces the set time.
Changing an Access Code
¾ To change an Access Code:
1. Enter Program Mode.
2. Verify the Access Code Length (Option 28).
3. Press the Add button from the Start Menu.
4. Press the Access Code button until you hear the name of the Access Code you want to
change.
5. Press the Done button to select the Access Code.
6. Using the numbered keys, enter the new access code. The panel will repeat the Access Code
after the last digit is entered.
Š Pressing the Cancel button after entering an access code will not revert to the old access code.
Go through the steps again if you make a mistake.
Figure 4. Programming Overlay
Tab
Figure 3. Cover Tab Location
+
-
+
-
START MENU
MAIN MENU
Delete
press
Delete
To delete an option or access code
and follow voice prompts.
Cancel
Cancel
Minutes
See Note
DONE
, then
If you make a mistake or want to start
over press
Account No.
Add Option
I N S T R U C T I O N S
Add
Add
Press
Clock Set
DONE
Option #
Press
Set Clock
Phone No. Option #3:
Option #2:
Panel Voice Enable Option #1:
Press for program information. *
use red numbers to enter access code.
voice prompts.
Add Access Code
Hours
Access Code
See Note
Hold key or press repeatedly
until you hear the desired item.
Note:
See Note
Press and follow
Add
Cancel
Access Code
Sensor
Option #
*
*
Delete
Test
Clock Set
DONE
Hours
Minutes
422-30
1
3
R
ev
C
2
4
5
3
1
8
9
0
7
6