Grizzly G0527 - Manual (Page 23)

G0527 18" Wide Belt Sander -21-
Adjusting Feed Rate Table Movement
The feed belt motor and gear assembly ( Figure
13) controls the speed of the feed belt. The Model
G0527 features feed belt speeds of 16.4, 23, and
32.8 FPM.
Figure 13. Table drive chain and sprockets.
To change feed belt speed:
1. Disconnect the sander from the power
source!
2. Remove the cap screw that secures the feed
belt motor cover.
3. Loosen the motor mount bolts so that the
motor will slide up enough to get the chain off
the sprockets.
4. Determine which speed is best for your appli-
cation and place the chain accordingly.
5. Tighten the motor mount bolts loosened in
step 3.
6. Replace the motor cover and secure it with
the cap screw removed in
step 2.
32.8
23
16.4
The table height can be adjusted either manually
or by power assist.
Manual Adjustment—Manual adjustments are
made by turning the handwheel located under the
front of the infeed table. The thickness measure-
ment is displayed on the digital readout.
Power Assist—Press the TABLE UP or TABLE
DOWN key on the control panel shown in Figure
12. The digital display reading changes as the
table moves up and down.
2 3
5 6
8 9
0
Figure 12. Controls for adjusting
the table height.
NOTICE
The thickness gauge is pre-calibrated from
the factory; however, correct calibration
should be verified by using the instructions
on page 27.