GE 49218 - Manual (Page 17)

16 17
Built-in units
RAK65A1 Window Installation Kit
for “J” Series Built-in Units
Adapts built-in wall case for window installation. (This kit is
included in “J” series units designed for window installation.)
Window opening width—26-7/8" to 40". Window opening height
—16-/8" minimum.
RAD4A1 Drain Kit
Internal/External Drain Kit
Drain kit for use on “J” series wall cases. For more positive
control of condensate water, the RAD4A1 drain kit routes
condensate to the exterior or to the interior of the building
through the wall case. Suitable provision (field applied) should
be made to connect the drain tube to a drain system in the
building. Drain tube assembly is 1/2" O.D. copper.
Note: The RAG14E exterior grille is NOT compatible with the
RAD4A1 EXTERNAL drain tube. Use of this grille would require
the use of the INTERNAL TUBE configuration to drain the unit.
RAB47/48 Tenant Option Wall Cases for “J” Chassis
When the air conditioner is offered as a tenant option, these
wall cases provide protection against outside elements.
RAB47—includes wall case, exterior grille, weather panel and
steel closure panel.
RAB48—includes wall case, exterior grille, insulated steel indoor
closure panel and insulated outdoor panel.
RAB46 Standard Wall Case
for “J” Chassis Built-in Unit
Solid-sided wall case fabricated of galvanized steel with baked
enamel (beige) finish. Welded areas are coated with a sealing
compound to help resist rust and corrosion. Polymer gasket
surrounds opening to assure tight weather seal. Aluminum grille
(RAG1) is included. Panels on interior and between case and
grille provide weather protection prior to installation of chassis.
Built-in units
RAF622 Replacement Room Front
for Rounded Front “J” Chassis
Used as replacement grille for rounded front “J” chassis units.
(Not for use with high mount units.)
RAG14E Architectural Louvered Exterior Grille
for “J” Series
Extruded aluminum grille for application with RAB46, 47, or 48.
NOTE: The RAG14E exterior grille is NOT compatible with the
RAD4A1 EXTERNAL drain tube. Use of this grille would require
the use of the INTERNAL TUBE configuration to drain the unit.
RAG13 Stamped Aluminum Exterior Grille “J” Series
Used to replace exterior grille on old “J” wall case to maximize
efficiency and capacity of new chassis. The grille is included
with new wall cases RAB46, 47, or 48.
RAF622A Replacement Room Front
for Rounded Front “J” Chassis
• Replacement Room Front for “J” series chassis with Oval
Control Knob opening.
• Not for use on High Mount Models.
RAK690 Architectural Louver Grille Adapter
for “J” Chassis Units
Permits most existing architectural louvered grilles to be used
with sloped front or rounded front “J” chassis units. Kit consists
of two wire mesh screen sections, clips to attach screen to
existing wall case, and two aluminum air deflectors to be
mounted to new chassis.
RAK66 Wall Case Insulation Kit
Kit consists of an insulated steel front cover and a black-painted
ESP rear cover. When installed in a RAB46 standard wall case,
the kit will protect room from the outside elements prior to
installation of a GE “J” series chassis.