Installation instructions, Installing the refrigerator, Turn on the water supply – GE BOTTOMFREEZER 200D9366P004 User Manual

Page 16: Plug in the refrigerator, Put the refrigerator in place, Level the refrigerator, Cont.)

Advertising
background image

CONNECTING THE REFRIGERATOR TO
THE HOUSE WATER LINE
(cont.)

If you are using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the GE SmartConnect

tubing, the nuts are already assembled to
the tubing.
If you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect

tubing,

insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.

One of the illustrations below will look like
the connection on your refrigerator.

Icemaker-Ready models

Icemaker-Installed Models

16

Installation Instructions

1

A

B

C

1/4

″ Tubing

Tubing Clamp

1/4

Compression
Nut

Ferrule
(sleeve)

SmartConnect

Tubing

Refrigerator
Connection

TURN ON THE WATER SUPPLY

(icemaker models)

Turn the water on at the shutoff valve (house
water supply) and check for any leaks.

2

PLUG IN THE REFRIGERATOR

On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the O (off) position.

See the grounding information attached to the
power cord.

3

PUT THE REFRIGERATOR IN PLACE

Move the refrigerator to its final location.

4

1/4

″ Copper

Tubing

1/4

Compression
Nut

Ferrule
(sleeve)

SmartConnect

Tubing

Refrigerator
Connection

Tubing
Clamp

LEVEL THE REFRIGERATOR

Adjustable legs at the front corners of the
refrigerator should be set so the refrigerator is
firmly positioned on the floor, and the front is
raised just enough that the door closes easily
when opened about halfway.

To adjust the leveling legs, turn the legs
clockwise to raise the refrigerator,
counterclockwise to lower it.

5

INSTALLING THE REFRIGERATOR

(cont.)

Advertising