GE BOTTOMFREEZER 200D9366P004 - Manual (Page 23)

Installation Instructions
TRANSFER CENTER HINGE
BRACKET
(cont.)
Transfer the plug button and screw hole
cover in the hinge holes on the left side
to the right side.
Install the new center hinge bracket from the
kit on the left side.
3
C
REMOVE THE FREEZER DOOR
Tape the door shut with masking tape.
Remove hinge pin from hinge bracket. This will
be used again with the new hinge bracket for
the other side.
Remove the tape and tilt the door away from
the cabinet. Lift the door off the bottom
hinge pin.
Remove the button plug from the left side of
the door. Remove the door thimble from the
right side of the door. Install the door thimble
into the hole on the left and the button plug
into the hole on the right.
Set the door on a non-scratching surface, with
the inside up.
2
A
B
C
D
TRANSFER CENTER HINGE BRACKET
Using a 5/16
″ socket ratchet/driver, remove the
bolts securing the center hinge to the cabinet.
3
A
B
REMOVE BOTTOM HINGE AND
LEVELING LEG
Using a 1/2
″ socket ratchet/driver, remove the
nut and hinge pin from the hinge bracket with
leveling leg. Using a 5/16
″ socket ratchet/driver,
remove the screws from the bottom hinge
bracket. These will be reinstalled on the
other side.
Using a 5/16
″ socket ratchet/driver, remove
the screws from the leveling leg bracket on
the other side. These will be reinstalled on the
opposite side.
4
A
B
23
Bottom Hinge
Bracket
Leveling Leg
Bracket
E