Grizzly G0526 - Manual (Page 21)

G0526 6" Jointer -19-
Components and Hardware Needed: Qty
Cutterhead Guard ........................................1
Tools Needed:
2.5mm Allen Wrench....................................1
To install the cutterhead guard:
1. Slide the cutterhead guard shaft down
through the mounting hole on the table.
Note—
The guard may not fully seat in the
hole initially; however, rotating the guard will
allow the shaft to fully seat in the hole.
2. Using a 2.5mm Allen wrench, thread the
setscrew through the hole in the forked end
of the cutterhead guard shaft (
Figure 17 ).
Note— Thread the setscrew far enough to
prevent the guard from being pulled out.
Components and Hardware Needed: Qty
V-Belt Guard ................................................1
Hex Bolt
5 ⁄
16
"-18 x 2 1 ⁄
2
"..................................1
Flat Washer 5 ⁄
16
" ..........................................1
Tools Needed:
12mm Wrench or Socket ............................1
To install the V-belt guard:
Using a 12mm wrench, secure the V-belt guard
over the cutterhead pulley and V-belt with the hex
bolt and flat washer (
Figure 18 ).
Figure 17. Cutterhead guard setscrew.
Figure 18. Correctly installed V-belt guard.
V-Belt Guard
V-Belt Guard Cutterhead Guard
NOTICE
The cutterhead guard must always return to
the closed position whenever it is moved.
Repeat steps 1-3 until this occurs.
3. Raise the fence and rotate the guard one
revolution counter-clockwise as it appears
from the top. Hold the guard in position.
4. Lower the fence and allow the guard to swing
back against the fence.