Grizzly G0526 - Manual (Page 31)

G0526 6" Jointer -29-
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition (free from cracks, fraying and wear).
Check the V-belt at least every 3 months; more
often if the jointer is used daily.
The carbide cutters are typically rotated at the
same time when they become dull; however, the
cutters can also be rotated individually when one
becomes nicked or damaged. Refer to
Section 8:
Service Adjustments for instructions on rotating
or replacing the carbide cutters .
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
Table ways and the fence assembly should not
be lubricated. If the tables appear to be stuck, dis-
assemble and clean any foreign materials from
the ways. Re-assemble and reset the gibs.
Carbide Cutters
Lubrication V-Belts