GE DVL223 - Manual (Page 19)

19
Reversing the Dryer Door Swing
Open the dryer door. Remove the 4 hinge hole
plugs or screws from the left side of door
opening. Place nearby for future installation.
NOTE: You may need a plastic knife to help pull out
the plugs. Be careful not to scratch the paint.
Remove the four screws that secure the door
hinges to the dryer front panel. NOTE: Remove
1 screw from each of the 2 hinges first. Hold the
door firmly before removing the last 2 screws.
Rotate the door 180° and reinstall the door
hinges to the dryer front panel with the 4 screws.
Install the 4 hinge hole plugs or screws that were
removed in step 1 into the open screw holes on
the right side of the door opening.
4
3
2
1
Replacement Parts
If replacement parts are needed for your dryer,
contact the source where you purchased your dryer.
CAUTION: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper and dangerous operation.
Verify proper operation after servicing.
WARNING: Destroy the carton and plastic bags
after the dryer is unpacked. Children might use
them for play. Cartons covered with rugs,
bedspreads or plastic sheets can become
airtight chambers causing suffocation. Place all
materials in a garbage container or make
materials inaccessible to children.
WARNING: The instructions in the manual and
all other literature included with this dryer are
not meant to cover every possible condition and
situation that may occur. Good safe practice
and caution MUST be applied when installing,
operating and maintaining any appliance.
Remove 4 screws—one from each hinge first
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions