Grizzly G0605X - Manual (Page 27)

G0605X/G0606X Extreme Series 12" Table Saw
-25-
Figure 31. Switch installed.
Figure 32. Miter gauge installed.
Washer
Handle
2. Slide the miter gauge into the miter gauge
slot to the left of the blade; or store it tempo-
rarily on the brackets near the blade angle
handwheel.
Components and Hardware Needed: Qty
Miter Gauge ....................................................... 1
Miter Gauge Handle .......................................... 1
Flat Washer 8mm .............................................. 1
To install the miter gauge:
1. Install the miter gauge handle and 8mm flat
washer onto the miter gauge as shown in
Figure 32.
Miter Gauge
Fence Components
Components and Hardware Needed: Qty
Fence Knob ....................................................... 1
Fence Resting Brackets .................................... 2
Flange Bolts M8-1.25 x 12 ................................. 2
To install the fence knobs, fence, and fence
resting brackets:
1. Install the fence knob as shown in Figure
33.
Figure 33. Fence knob installed.
2. Install the fence onto the table to the right of
the blade.
3. Install the fence resting brackets (Figure 34)
onto the cabinet under the Outfeed Table
with two flange bolts.
Figure 34. Fence resting brackets installed.
Brackets
Stop Paddle
Flange Bolt
Anti-Start
Safety Pin