Grizzly Model G1022proz - Manual (Page 23)

G1022 Series Table Saws -21-
All Models:
8. Place the assembled stand upside down on
the table saw body and align all the mounting
holes.
Make certain the side of the stand with
the “Z Series” label, if applicable, is on the
front side of the machine (the side with the
Grizzly label and angle scale).
9. Secure the stand to the body using M8-1.25
x 19 hex bolts, 8MM flat washers and M8-
1.25 hex nuts, with the dust port sandwiched
between on the Models ZF, ZFX, PROZ, &
PROZX, as shown in
Figure 13 .
Figure 13. Attaching the stand to the saw base.
10. With the help of a second person, flip the
entire table saw unit right side-up and move
it into its working position.
11. Tighten all of the stand bolts.
Saw Body
Stand
Dust Hood
(ZF, ZFX, PROZ,
& PROZX Only)
Dust Hood Adapter
(ZF, ZFX, PROZ, &
PROZX Only)
Figure 14. Mounting the handwheels.
To mount the handwheels:
1. Position one of the handwheels over the
arbor lifting shaft on the front of the saw.
2. The slots in the handwheel hole will engage
with the roll pin on the shaft as shown in
Figure 14 .
3. Position the other handwheel on the blade
tilting shaft located on the side of the saw.
4. Screw the black plastic lock knobs onto the
ends of the shafts to lock the handwheels in
place.
Handwheels
Roll Pin
Body mounted switch on
Models SM & Z only
The Model G1022 Series
is a heavy machine,
weighing up to 340 lbs.
Personal injury could
occur if the machine is
moved without addition-
al assistance. Seek the
assistance of other peo-
ple when moving or lift-
ing the machine.