Grizzly Model G1022proz - Manual (Page 51)

G1022 Series Table Saws -49-
Blade Parallelism
To check and adjust blade parallelism:
1. Disconnect the machine from the power
source!!
2. Tilt the blade to 90˚. Using an adjustable
square, measure the distance (A) between
the miter slot and the front of the blade as
shown in
Figure 59 .
The Model G1022 Series Table Saws will perform
best when the miter slot is parallel to the blade.
Figure 59. 90° blade parallelism measurement.
Figure 60. 90° blade parallelism measurement.
3. Rotate the blade 180° and measure the dis-
tance (B) between the miter slot and the
back of the blade as shown in
Figure 60 .
Use caution and remain
alert when working
around the saw blade.
Failure to follow this
warning could result in
serious personal injury
or death.
SECTION 8: SERVICE ADJUSTMENTS
!
!