Grizzly Model G1022proz - Manual (Page 34)

-32- G1022 Series Table Saws
Figure 41. Proper splitter/blade alignment.
13. Recheck guard alignment to the blade and to
the table top. Adjust as necessary and tight-
en down all the bolts before use.
14. Adjust the blade to 45° and raise and lower
it through the full range. Re-adjust blade to
90° and raise and lower it through the full
range. There should be no contact between
the base and the table insert or any other
part of the saw. If there is, repeat
Steps 1-
13 .
10. If the blade guard/splitter is to the right of the
blade as shown in
Figure 40 , add washers
between the splitter and front mounting
bracket and adjust the rear splitter support as
shown in
Figure 40 .
Figure 40. Improper splitter/blade alignment.
Figure 39. Checking alignment of blade guard.
9. Next, set a straightedge against the face of
the saw blade and the blade guard/splitter as
shown in
Figure 39 . If the blade guard/split-
ter is properly aligned, please skip ahead to
the next section; otherwise, continue with the
next step.
11. Recheck guard alignment to the blade and to
the table top. Adjust as necessary and tight-
en all the bolts before use. If the blade guard
is properly aligned, please skip ahead to the
next section; otherwise, continue with the
next step.
12. If the splitter is positioned to the left of the
blade, alignment cannot be achieved by
washer placement. Adjustment of the front
support bracket is required as shown in
Figure 41 . Loosen the adjustment screws
and move the front support bracket to the
right.
Splitter
Added Washers
Front Support
Bracket
Adjustment
Screw
Adjusted
Rear Splitter
Adjust here
to move back
of splitter left
or right.
Add washers
here to move
front of split-
ter to the left.
Blade
Proper Alignment
!