Orbital action – Grizzly H0601 User Manual
Page 10
Advertising
H0601 14.4V Cordless Jig Saw
-8
-
There are four settings for orbital action of
the blade, controlled by a lever switch. The
effect of the settings is shown in
Figure 5
below. When set on Position III the blade
oscillates forward in the stroke, which is
helpful when cutting wood or soft materi-
als. The Position 0 setting eliminates all
forward oscillation and the blade strokes
ORBITAL ACTION
straight up and down. This is good for
materials with a strong cutting resistance
such as metals and where a very clean cut
edge is desired.
Changes in the orbital movement can be
made with the motor turned on.
Fig 5. Orbital movement settings and typical materials for each selection.
Advertising