Genie TML-4000N - Manual (Page 18)

16 Genie TML-4000 and TML-4000N Part No. 97600
Operator's Manual Third Edition • Second Printing
Workplace Inspection
Fundamentals
The workplace inspection helps the operator
determine if the workplace is suitable for safe
machine operation. It should be performed by the
operator prior to moving the machine to the
workplace.
It is the operator's responsibility to read and
remember the workplace hazards, then watch for
and avoid them while moving, setting up and
operating the machine.
Be aware of and avoid the following hazardous
situations:
· Drop-offs or holes
· Bumps and obstructions
· Debris
· Slopes that exceed the machine’s leveling
capability
· Unstable or slippery surfaces
· Overhead obstructions and high voltage
conductors
· Hazardous locations
· Inadequate surface support to withstand all
load forces imposed by the machine
· Wind and weather conditions
· The presence of unauthorized personnel
· All other possible unsafe conditions
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
Know and understand the workplace
inspection before going on to the next
section.
5 Only use the machine as it was intended.