Genie TML-4000N - Manual (Page 5)

Operator's Manual Third Edition • Second Printing
Part No. 97600 Genie TML-4000 and TML-4000N 3
SAFETY RULES
Keep away from the
machine if it contacts
energized power lines.
Personnel must not
touch or operate the
machine until power
lines are shut off.
Do not connect wires
directly to the generator.
Connect auxiliary
equipment only to the
power outlets provided.
Inspect the power cord for damage prior to each
use. Replace any damaged cord before operating.
Do not allow the power cord to become caught or
crushed while raising, lowering or rotating the mast.
Avoid electrical shock from contact with battery
terminals. Remove all rings, watches and other
jewelry.
This machine should be grounded in accordance
with all local electrical codes. Consult the local
electrical codes or Authority Having Jurisdiction in
the area where the machine will be used for specific
requirements.
Collision Hazard
Check the work area for overhead obstructions or
other possible hazards.
Bodily Injury Hazard
Do not grasp the cable.
Use proper lifting techniques when lifting and
positioning the tongue of the machine.
Always replace the protective lamp cover after
replacing the lamp bulbs.
Burn Hazard
Do not touch the lamp fixtures while they are turned
on. Turn the lamps off and allow them to cool
before touching.
Crushing Hazards
Do not lower the mast unless the area below is
clear of personnel and obstructions.
Do not release the spring latch on the side of the
machine unless the mast sections are fully
retracted.
Keep hands and fingers away from any potential
pinch points.
Damaged Machine Hazards
Do not use a damaged or
malfunctioning machine.
Do not use a machine with
a worn, frayed, kinked or
damaged cable.
Be sure the operator's
manual is complete, legible
and in the storage container
located on the machine.
Be sure all decals are legible and in place.