GE 197D3354P013 User Manual

Page 21

Advertising
background image

ge.com

C

o

n

su

m

e

r

S

u

p

p

o

rt

Tr

o

u

b

le

sh

o

o

tin

g

Ti

p

s

O

p

e

ra

tin

g

In

st

ru

c

tio

n

s

S

a

fe

ty

In

st

ru

c

tio

n

s

In

st

a

lla

tio

n

In

st

ru

c

tio

n

s

Problem

Possible Causes

What To Do

Moisture collects inside

Too frequent or too

(in humid weather, air

long door openings.

carries moisture into

Open containers of water or

• Cover or seal open containers. During a defrost cycle,

refrigerator when doors

warm food in the refrigerator.

moisture will be removed from the refrigerator, but may

are opened)

return with long or frequent door openings.

Hot air from bottom

Normal air flow cooling motor. In the refrigeration process,

of refrigerator

it is normal that heat be expelled in the area under the refrigerator.
Some floor coverings will discolor at these normal and safe temperatures.

Food freezing in

Food too close to the air vent

• Move the food away from the air vent (near the

the refrigerator

at the back of the refrigerator.

controls).

Refrigerator control is set

• Move the refrigerator control to a warmer

too cold.

temperature setting one increment at a time.

Orange glow

Defrost heater is on.

• This is normal.

in the freezer
Door bins do not fit

The freezer door bins are

• Try to install the bins in both doors.

in the door

a different size than the
refrigerator door bins.

Freezer light does

Some models do not have a

• Check for a semi-clear dome light shield in the freezer ceiling.

not work

freezer light.

If the dome is opaque white, the model does not have a freezer
light. Check for a door activated light switch on the right side of
the freezer. If there is only a cap in place of a switch, the model
does not have a freezer light.

Light bulb burned out

• See Replacing the light bulbs.

or loose.

Controls do not light up

Some models do not have

• If you can read white numbers on the control setting,

lighted controls.

the model does not have lighted controls.

Refrigerator light bulb burned

• See Replacing the light bulbs.

out or loose.

Ice bucket does not fit

The freezer shelf is in the

• Place the shelf in the lower position. See Rearranging

under the icemaker

top position.

the shelves.

Water has poor

Water dispenser has not been

• Dispense water until all water in system is replenished.

taste/odor

used for a long time.

Water in first glass

Normal when refrigerator

• Wait 24 hours for the refrigerator to completely cool down.

is warm

is first installed.
Water dispenser has not been

• Dispense water until all water is system is replenished.

used for a long time.
Water system has been drained.

• Allow several hours for replenished supply to chill.

Water dispenser

Water supply line turned off

• See Installing the water line.

does not work

or not connected.
Water filter clogged.

• Replace filter cartridge or remove filter and install plug.

Air may be trapped in

• Press the dispenser arm for at least 2 minutes.

the water system.

Water spurting from

Newly-installed filter cartridge.

• Run water from the dispenser for 3 minutes

dispenser

(about 1

1

2

gallons).

Water is not dispensed

Water in reservoir is frozen

• Set the refrigerator control to a warmer setting and

but icemaker is working

because the controls are

wait 24 hours. If water does not dispense after 24 hours,

set too cold.

call for service.

No water or ice cube

Supply line or shutoff valve

• Call a plumber.

production

is clogged.
Water filter clogged.

• Replace filter cartridge or remove filter and install plug.

Filter cartridge not

• Remove and reinstall filter cartridge, being certain that

properly installed.

it locks into place. The blade on the end of the cartridge
should be positioned vertically.

Water is leaking from

Glass not being held under

• Hold the glass underneath the dispenser for 2–3 seconds

dispenser

the dispenser long enough

after releasing the dispenser button. Water may continue

after button is released.

to dispense after the button is released.

Air may be present in the

• Dispense water for at least 2 minutes to remove air

water line system, causing

from system.

water to drip after being
dispensed.

21

Advertising