Grizzly H7951 - Manual (Page 13)

h7949/h7950/h7951 nailer -10 -
rotating exhaust
cover
the exhaust cover rotates as needed to
direct the exhaust away from you.
to rotate the exhaust cover:
1. use the 4mm hex wrench to loosen the
exhaust cover cap screw as shown in
figure 10.
figure 10. loosening the exhaust cap
screw.
2. rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3. tighten the exhaust cover cap screw.
unloading nails
to remove unused nails:
1. DisConnECt nailEr FroM thE
air supply!
2. point the nailer away from you and all
bystanders.
3. open the magazine cover (as shown
on page 8) and lift the nails from maga-
zine.
4. Close the magazine cover to keep
the magazine assembly clean until the
nailer is reloaded.
Exhaust
Cap screw