Generac 004700-0 - Manual (Page 32)

30 Generac ® Power Systems, Inc.
2.6.5 ISOLATING DIFFERENT POWER
SOURCES
Connections from the junction box must terminate in
a double-pole, double-throw transfer switch (Figure
2.14). An alternate method for isolating different
power sources is by using an isolating receptacle
(Figure 2.15). Whichever method you use, you must
be certain that both power sources are NOT connect-
ed at the same time.
2.6.6 POWER SUPPLY CORD
The power supply cord must comply with all applic-
able codes, standards and regulations. It must be
large enough to handle the full amperage to which it
will be subjected.
◆ ◆
Section 2 – Installation
QUIETPACT 40G Recreational Vehicle Generator
GENERA
C OHV I POW ER ED
GENE RAC OHVI I NDUS TRIAL ENGIN E
QUIETP
ACT 40G
RV SE RV ICE LOC ATOR : 1.8 00.3 33.1 322
G E N E R A C P ow er Sys tem s, Inc - Whitewater, W I
® ®
Figure 2.14 – Transfer Switch Isolation Method
Figure 2.13 – Installation With Isolation Receptacle
GEN ER AC OHVI PO W ERED
GENE RAC O HVI IN DUST RIAL E NGIN E
QUIETP
ACT 40G
RV SER VICE LO CA TO R: 1 .80 0.3 33.1 322
G E N E R A C P ow er Sys tem s, Inc - Whitewater, W I
® ®