GE DCVH515 - Manual (Page 19)

– 19 –
Stacking Instructions
The GE dryer is designed to allow placement
(stacking) on top of certain GE front load washers.
Washer models that currently qualify are:
WBVH6240
WCVH6260
WHDVH626
The parts and instructions necessary to convert the
separate units to a stack unit are included with the
washer installation parts.
Note: The stacking parts and instructions are NOT
included with the GE dryers but can be ordered
separately. (Part # WE25X10018)
Note: Reverse the dryer door swing (if desired)
BEFORE stacking. The washer door swing is NOT
reversible.
•
•
•
WARNING!
• Make sure the dryer is unplugged.
• More than 2 people are recommended to safely
lift the dryer into position.
• Avoid damage to the existing utility services.
DO NOT place the washer on top of the dryer.
Stacking of a gas dryer is NOT permitted in a
mobile home or a manufactured home.
Location Requirements
When installed in a location other than an alcove
or closet, the minimal clearances to combustible
surfaces and for air opening are: 0 inches on both
sides, and 1 inch at the rear.
Note: If your dryer is approved for installation in an
alcove or a closet, it will be stated on a label on the
back.
When installed in an alcove or closet:
Minimum clearance between dryer cabinet
and adjacent walls or other surfaces is 0 inches
either side, and 3 inches front and rear.
•
•
•
Minimum vertical space from fl oor to overhead
cabinets, ceiling, etc. is 43 inches without
pedestal, 55 inches with pedestal, and 84
inches stacked. Closet doors must be louvered
or otherwise ventilated and must contain a
minimum of 120 square inches of open area,
equally distributed.
The dryer MUST be vented to the outdoors.
(Refer to dryer installation instructions for
details.)
•
•
Tools Needed
Kit Contents
(Continued Next Page)
Right Bracket
Left Bracket
4 Rubber Pads
4 #12 x 1" Screws
4 #8 x ½" Screws
Phillips Screwdriver
Open End Wrench
Pliers
Gloves
Level