Grizzly H8145 - Manual (Page 21)

H8145 Baby Table Saw
-19-
Blade Tilt/Bevel Cuts
The blade can tilt from 0° to 45° to make beveled
cuts. Beveled cuts are made in the same manner
as rip cuts.
To tilt the blade:
1. DISCONNECT SAW FROM POWER!
2. Loosen the lock handles at the front and back
of the machine.
Note: The lock handles have a ratcheting
action. Disengage them by pulling back on
the handle. When held back (disengaged),
the handles will rotate in either direction with-
out turning the threads. When you let go of
the handles, the internal spring will automati-
cally engage them again so the threads turn
with the handles.
3. Tilt the motor/blade assembly until the pointer
shown in Figure 16 points to the desired
blade tilt angle.
4. Tighten the front and rear lock handles to lock
the blade in place.
Changing Blade
Tools Needed Qty
• Arbor Wrench 19mm .................................. 1
• Arbor Wrench 8mm .................................... 1
• Phillips Screwdriver #2 ............................... 1
To change the blade:
1. DISCONNECT SAW FROM POWER!
2. Remove the two screws shown in Figure 17,
then remove the blade cover.
Figure 17. Blade cover screws.
Figure 18. Wrench positions to remove arbor
hex nut.
3. Hold the blade arbor with the small arbor
wrench, then use the large arbor wrench
to remove the arbor hex nut, as shown in
Figure 18.
4. Remove the old blade and reinstall the new
blade, making sure that the blade flanges get
reinstalled on both sides of the blade.
5. Replace and tighten the arbor hex nut, then
re-install the blade cover.
Figure 16. Tilt scale and pointer.
Tilt Scale
Pointer
Blade Flange