Maxtor Computer Drive - Manual (Page 16)

General Description
Maxtor DiamondMax 8S 40GB SATA 2-4
2.4 REGULATORY COMPLIANCE STANDARDS
Maxtor Corporation’s disk drive products meet all domestic and international product
safety regulatory compliance requirements. Maxtor’s disk drive products conform to
the following specifically marked Product Safety Standards:
• Underwriters Laboratories (UL) Standard 1950. This certificate is a
category certification pertaining to all 3.5-inch series drives models.
• Canadian Standards Association (CSA) Standard C.22.2 No. 1950. This
certificate is a category certification pertaining to all 3.5-inch series
drives models.
• TUV Rheinland Standard EN60 950. This certificate is a category
certification pertaining to all 3.5-inch series drives models.
Product EMI/EMS Qualifications:
• CE Mark authorization is granted by TUV Rheinland in compliance
with our qualifying under EN 55022:1998 and EN 55024:1998.
• C-Tick Mark is an Australian authorization marked noted on Maxtor’s
disk drive products. The mark proves conformity to the regulatory
compliance document AS/NZS 3548: 1995 and CISPR 22: 2002.
• Maxtor’s disk drives are designed as a separate subassembly that conforms to the
FCC Rules for Radiated and Conducted emissions, Part 15 Subpart J; Class B
when installed in a given computer system.
• Approval from Taiwan BSMI. Number: 3892A638
2.5 HARDWARE REQUIREMENTS
The DiamondMax 8S 40GB SATA hard disk drives are compatible with SATA
equipped IBM PC AT computers and SATA equipped systems that are compatible
with the IBM PC AT. It connects to the PC either by means of a third-party SATA
adapter board, or by plugging a cable from the drive directly into a PC motherboard
that supplies an SATA interface. The DiamondMax 8S 40GB SATA is also compatible
with Serial ATA equipped Host Bus Adaptors (HBAs) in storage sub-systems and
other non PC applications.