Maxtor Computer Drive User Manual

Page 54

Advertising
background image

ATA Bus Interface and ATA Commands

Maxtor DiamondMax 8S 40GB SATA

5-18

93

Hardware reset result. The contents of bits (12:0) of this word shall change only
during the execution of a hardware reset

15:

Shall be cleared to zero.

14:

Shall be set to one.

13:

1 = device detected CBLID- above ViH. 0 = device detected CBLID-
below ViL

12-8:

Device 1 hardware reset result. Device 0 shall clear these bits to zero.
Device shall set these bits as follows:

12:

Reserved.

11:

0 = Device 1 did not assert PDIAG-.
1 = Device 1 asserted PDIAG-.

10-9:

These bits indicate how Device 1 determined the device number:

00 = Reserved.

01 = a jumper was used.

10 = the CSEL signal was used.

11 = some other method was used or the method is unknown.

8:

Shall be set to one.

7-0:

Device 0 hardware reset result. Device 1 shall clear these bits to zero.
Device shall set these bits as follows:

7:

Reserved.

6:

0 = Device 0 does not respond when Device 1 is selected.
1 = Device 0 responds when Device 1 is selected.

5:

0 = Device 0 did not detect the assertion of DASP-.
1 = Device 0 detected the assertion of DASP-

4:

0 = Device 0 did not detect the assertion of PDIAG-.
1 = Device 0 detected the assertion of PDIAG-.

3:

0 = Device 0 failed diagnostics.
1 = Device 0 passed diagnostics.

2-1:

These bits indicate how Device 0 determined the device number:

00 = Reserved.

01 = a jumper was used.

10 = the CSEL signal was used.

Word

Content Description

Advertising