Mercedes-Benz 2003 C-Class Coupe User Manual

Page 49

Advertising
background image

49

Getting started

Driving

Single wipe

̈

Press switch briefly in the direction of
arrow 1.

The windshield wipers wipe one time
without washer fluid.

Wiping with windshield washer fluid

̈

Push switch in the direction of arrow 1
past the resistance point.

The windshield wiper operates with
washer fluid.

i

Vehicles without rain sensor*: Fast
wiper speed III goes to setting II when
the vehicle is standing still.

Vehicles with rain sensor*: Intermittent
wiping interval dependent on wetness
of windshield. Wiping will not occur
with a door open.

!

Vehicles with rain sensor*: Do not
leave in intermittent setting when vehi-
cle is taken to an automatic car wash or
during windshield cleaning. Wipers will
operate in presence of water sprayed
on the windshield, and wipers may be
damaged as a result.

The switch should not be left in inter-
mittent setting as the wipers will wipe
the windshield once every time the en-
gine is started. Dust that accumulates
on the windshield might scratch the
glass when wiping occurs on a dry
windshield.

!

If leaves, snow, etc. block the wind-
shield wipers, switch off the wipers.

ț

For safety reasons, withdraw key
from starter switch. Remove block-
age.

ț

Turn the windshield wipers on
again.

If windshield wipers fail to function at
all in switch position I,

ț

set the combination switch to the
next highest wiper speed.

ț

have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center.

Advertising
This manual is related to the following products: