Magnadyne MV6000 - Manual (Page 9)

Power Harness Wiring:
The 3 wire harness provides battery and igni-
tion 12 volts as well as a chassis ground.
Route the power harness to the point in the
vehicle that you will make the connections.
Red Wire: The red wire in the harness should
be connected to a +12 volt power wire that
is turned on and of by the position of the
ignition key.
Yellow Wire: The yellow wire in the harness
should be connected to a constant +12 volt
wire that is NOT turned on and off by the
position of the ignition key.
Black Wire: The black wire in the harness
should be connected to the chassis of the
vehicle using a ring terminal and self tap-
ping screw or existing bolt and nut.
Dome Light Harness Wiring:
Follow the enclosed wiring to connect the
MovieVision dome light system to the factory
installed dome light wiring
For Negative Trigger Dome Light Systems
(typical to most vehicles):
Orange Wire: Connect to constant +12 volts.
Green Wire: Connect to the common trigger
wire coming from all door pin switches (-).
White Wire: Connect to chassis ground.
For Positive Trigger Dome Light Systems
(typical to many Ford vehicles):
Orange Wire: Connect to chassis ground.
Green Wire: Connect to the common trigger
wire coming from all door pin switches (+).
White Wire: Connect to constant +12 volts.
Auxiliary Input:
You may use video games, camcorders and
other portable video unit by connecting the
unit to the color-coded auxiliary input connec-
tors.
Note: These connectors are attached to black
wires.
Yellow RCA Connector: Video input.
Red RCA Connector: Audio input right.
White RCA Connector: Audio input left.
Video Output:
You may output video to an optional monitor.
Note: This connector is attached to a gray wire.
Yellow RCA Connector: Video output.
Wiring Instructions
9
MV6000-UM.qxp 4/5/05 16:13 Page 9