Meyer Sound UltraCompact High-Power Curvilinear Array Loudspeaker M'elodie - Manual (Page 33)

27
CHAPTER 7
STOW STOW
A B A B
GROUND STACK
FRONT LINK
GROUND STACK
REAR LINK
MAXIMUM DOWN-TILT
MAXIMUM UP-TILT
B A 0º B B -5º A B -10º
FRONT LINK REAR LINK RESULT ANGLE
-5º
0º
MG-M’ELODIE
B A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1 LOAD RATINGS
1550 lbs 702 kg (25 M’elodie)
1116 lbs 506 kg (18 M’elodie)
+/- 60 DEG.
0
3
6
9
11
STOW STOW
A B A B
GROUND STACK
FRONT LINK
GROUND STACK
REAR LINK
MAXIMUM DOWN-TILT
MAXIMUM UP-TILT
B A 0º B B -5º A B -10º
FRONT LINK REAR LINK RESULT ANGLE
-5º
0º
MG-M’ELODIE
B A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1 LOAD RATINGS
1550 lbs 702 kg (25 M’elodie)
1116 lbs 506 kg (18 M’elodie) +/- 60 DEG.
0
3
6
9
11
STOW STOW
A B A B
GROUND STACK
FRONT LINK
GROUND STACK
REAR LINK
MAXIMUM DOWN-TILT
MAXIMUM UP-TILT
B A 0º B B -5º A B -10º
FRONT LINK REAR LINK RESULT ANGLE
-5º
0º
MG-M’ELODIE
B A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT
CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1 LOAD RATINGS
1550 lbs 702 kg (25 M’elodie)
1116 lbs 506 kg (18 M’elodie) +/- 60 DEG.
0
3
6
9
11
Figure 7.6. MG-M’elodie grid’s link combinations
In addition, the up and down tilt of the MG-M’elodie and the
array hung underneath can be adjusted using chain motors,
or differing lengths of steel or span set.
CAUTION: Always use red button pins (5/16"
x 0.875") or blue button pins (used in M1Ds,
5/16" x 1.25") to secure each grid link to the MG-
M’elodie. Avoid using the black button pins (5/16”
x 0.63”) since they are shorter and will not lock in
place.
Using the MG-M’elodie for Ground-Stacking
In addition to its flown capabilities, the MG-M’elodie grid
forms a secure base for ground-stacking. For ground-
stacking, secure the bottom M’elodie enclosure to the
MG-M’elodie grid using the captive GuideALinks and red (or
blue) quick release pins. The grid allows two positions for
the rear link. The bottom position is used to achieve angles
from 0 to +11 degrees (uptilt) while the top position is used
to achieve angles from -5 degrees (downtilt) to +6 degrees
with respect to the grid.
A
STOW GROUND STACK FRONT LINK
MAXIMUM DOWN-TILT
MAXIMUM UP-TILT
B A 0º B B -5º A B -10º
FRONT LINK REAR LINK RESULT ANGLE
GROUND STACK REAR LINK
-5º
0º
B
STOW
A B
MG-M’ELODIE
B A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT
CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1 LOAD RATINGS
1550 lbs 702 kg (25 M’elodie)
1116 lbs 506 kg (18 M’elodie) +/- 60 DEG.
0
3
6
9
11
Figure 7.7. Ground-stacking M’elodie
THE MTF-MICA/M’ELODIE TRANSITION FRAME
When using M’elodie enclosures as downfill with a MICA
array, the MTF-MICA/M’elodie transition frame is used
between the lowest MICA and the top M’elodie. The MTF-
MICA/M’elodie can also be used to transition from 600-HP
subwoofers (fitted with MRF-600 rigging frames) to M’elodie
when flown or groundstacked to deploy a single array.
Figure 7.8. An array with MICA and M’elodie using the MTF-MICA/M’elodie
transition frame
0°
-5°
-10°