Meyer Sound UltraCompact High-Power Curvilinear Array Loudspeaker M'elodie - Manual (Page 35)

29
CHAPTER 7
CAUTION: Do not exceed five M’elodie
cabinets high to avoid tipping over the stack.
CAUTION: Avoid moving the M’elodie
stack in the front-to-back direction of the
loudspeakers (the long side); always move the stack
sideways to avoid tipping it over.
STOW STOW
A B A B
GROUND STACK
FRONT LINK
GROUND STACK
REAR LINK
MAXIMUM DOWN-TILT
MAXIMUM UP-TILT
B A 0º B B -5º A B -10º
FRONT LINK REAR LINK RESULT ANGLE
-5º
0º
MG-M’ELODIE
B A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1 LOAD RATINGS
1550 lbs 702 kg (25 M’elodie)
1116 lbs 506 kg (18 M’elodie) +/- 60 DEG.
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
Figure 7.13. The M’elodie stack should only be moved sideways when being
transported on the MCF-M’elodie caster frame
The M’elodie GuideALinks allow multiple transport angles
with the MCF-M’elodie caster frame.
■ Use the 5 position on the M’elodie rear GuideALink to
get the first M’elodie with respect to the caster frame at
0 degrees. This setting is preferred when all M’elodies
are at 0 degrees.
■ Use the 0 position to downtilt the first M’elodie with
respect to the caster frame, to compensate if the rest of
the M’elodies in the stack have severe angles.
0
3
6
9
11
Figure 7.14. First M’elodie at 0 degrees (straight-up) with respect to the
MCF-M’elodie
0
3
6
9
11
Figure 7.15. First M’elodie at -5 degrees (downtilted) with respect to the
MCF-M’elodie
TIP: The MG-M’elodie can travel installed on
top of a M’elodie stack.
Use position 5
Use position 0