Motorola 2.1 - Manual (Page 32)

Chapter 2: Network Setup
24 The server should reboot and bring up the Welcome screen. Click on the Next button to
continue.
25 Click on the Yes button to accept the License Agreement and then click on the Next button to
continue.
26 Verify the correct date and time for your server and then click the Next button to continue.
24 When the Monitor Configuration screen is displayed, your monitor should be detected and
selected by the installer. If your monitor type is not listed, choose a suitable setting from the
Generic CRT Display
category.
Choose the desired color depth and resolution. A recommended minimum is at least 16-bit
color and a 1024 X 768 resolution. Click on the Next button.
25 When the Customize Graphics Configuration screen is displayed, choose the desired color
depth and resolution. A recommended minimum is at least 16-bit color and a 1024x768
resolution. Click on the Next button.
26 At the Red Hat Network screen, make your selection and click on the Next button to continue.
27 You can enter the Remote Support User Account at this time.
It is highly recommended to add the meshmgr user for remote support
capabilities. Use the information below to create this account.
Username : meshmgr
Full Name : Remote Support
Password : g0ld10
Confirm Password : g0ld10
Click on the Next button to continue.
28 At the Additional CDs screen, click on the Next button if you have no other CDs to install at
this time.
29 The Finish Setup screen will be displayed. Click on the Next button to continue.
For optimal screen viewing configure the video adapter display resolution to at
least 1024 X 768.
To prevent the smartd alarm from occurring during the server boot process you
can execute "chkconfig --level 345 smartd off" at a command prompt.
2-18