Motion CL900 FWS-001 - Manual (Page 19)

Chapter 1 Getting Started Optional setup tasks 13
T IP : You may find it helpful to use a small screw driver or something similar to assist threading
the loop through the tight space of the tether attach point.
You can purchase pens from the Motion Computing Accessories page.
Connect the tablet to a docking station
The CL900 docking station is a separate accessory that you can purchase from the Motion
Computing Accessories page. The docking station has:
• Three USB ports to connect a keyboard, mouse, or other USB devices
• An Ethernet port to connect to a local network
• A pen tether attach point
To connect the tablet to a docking station
1. Connect the AC adapter to the port on the back of the docking station.
2. If desired, connect a mouse and or keyboard to USB ports on the back of the docking
station.
3. With the front of the dock facing you and holding the tablet upright, slip the tablet into
the dock.
T IP : You will know if the tablet is seated properly if the battery gauge located on the left side of
the tablet lights up.
Connect the tablet to a display monitor
Connect a display monitor directly to the CL900 tablet itself using the Micro-HDMI port
(located on the left side of the tablet) with an appropriate connector, such as a DVI-HDMI
adapter.
To set up an external monitor
1. Connect the monitor cable from the external monitor into the Micro-HDMI port on the
CL900.
2. Plug in the external monitor and turn it on.
3. If necessary, install software and drivers for the monitor. See the manufacturer’s
documentation for more information.
After connecting the monitor, set up the external display from the Motion Dashboard as
described in “Setting up an external display” on page 41.