Motorola USB08 - Manual (Page 17)

USB08 Evaluation Board Designer Reference Manual
MOTOROLA USB08 Quick Start 17
Designer Reference Manual — USB08 Evaluation Board
Section 1. USB08 Quick Start
1.1 Contents
1.2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
1.3 Required System Configuration . . . . . . . . . . . . . . . . . . . . . . . .17
1.4 Connecting the Demo Board to the PC . . . . . . . . . . . . . . . . . . 18
1.5 Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
1.6 Starting the Windows Demo Application. . . . . . . . . . . . . . . . . . 24
1.2 Introduction
This section describes the connection and startup of the USB08
(universal serial bus) evaluation board demo application. The main
component of the USB08 is the Motorola MC68HC908JB8 8-bit
microcontroller (MCU).
1.3 Required System Configuration
To connect the USB08, you will need a personal computer (PC) with one
of the following Microsoft
®
operating systems:
• Windows
®
98
• Windows ME
• Windows 2000 Professional
NOTE: Ensure that the PC has the necessary hardware (universal serial bus
(USB) host controller and USB root hub) and that the necessary system
drivers are installed.
Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States
and/or other countries.