Motorola USB08 - Manual (Page 207)

Universal USB Device Driver (USBIO)
Programming Interface
USB08 Evaluation Board Designer Reference Manual
MOTOROLA Universal USB Device Driver (USBIO) 207
USBIO_BIND_PIPE
The USBIO_BIND_PIPE structure provides information about the pipe to
bind to.
Definition typedef struct _USBIO_BIND_PIPE{
UCHAR EndpointAddress;
} USBIO_BIND_PIPE;
Member EndpointAddress
Specifies the address of the endpoint on the USB device that shall be
associated with the pipe. The endpoint address is specified as
reported in the corresponding endpoint descriptor.
The endpoint address includes the direction flag at bit position 7
(MSB).
Bit 7 = 1: OUT endpoint
Bit 7 = 0: IN endpoint
Refer to the Universal Serial Bus Specification 1.1, Chapter 9 for more
information.
Comments This structure has to be used as an input for IOCTL_USBIO_BIND_PIPE
(
page 174 ) operations. Only active endpoints from the current
configuration can be bound.