Minolta Dimage 5 - Manual (Page 27)

27
Open the card-slot door in the direction indicated (1).
Insert the CompactFlash card into the card slot until the card-eject lever pops out (4).
• Insert the card so the face is toward the front of the camera. Always push the card in straight,
never at an angle. Never force the card. If the card does not fit, check that it is orientated
correctly.
Fold the card-eject lever down as shown (5) and close the card-slot door.
To eject a CompactFlash card, lift (2) then press (3) the card-eject lever. The card can
now be pulled out.
• Take care when removing the card as it becomes hot with use.
If the card-not-recognised message appears, the inserted card in the camera may need
to be formatted. A CompactFlash card used in another camera may need to be format-
ted before being used. If the “unable-to-use-card” message appears, the card is not
compatible with the camera and should not be formatted. A card can be formatted in
the basic section of the setup menu (p. 116). When a card is formatted, all the data on
the card is permanently erased.
1 2 3 4 5
Always turn off the camera and confirm the access lamp is not lit before inserting or
removing a CompactFlash card otherwise the card may be damaged, and data lost.