MITSUBISHI ELECTRIC XD450U - Manual (Page 25)

EN - 25
ENGLISH
FEATURE
PASSWORD FUNCTION
XGA60 opt.
LOCK
UNLOCK
OK
OK
PASSWORD
CONFIRM
O K CANCEL
FEATURE
PASSWORD FUNCTION
XGA60 opt.
LOCK
UNLOCK
OK
OK
PASSWORD
O K CANCEL
Password function
This projector is equipped with the password function
that is designed for prevention of theft and wrong op-
eration by children and restriction on operation by other
than specified users. The password function has three
modes as follows.
DISPLAY INPUT ...........When the projector is turned
on, the startup screen (or splash screen) will appear
and stay on the screen until the password is entered.
When the password is entered, the startup screen
will switch to the regular operation screen.
MENU ACCESS ............All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You can
use this mode as a measure of prevention of wrong
operation by children and restriction on operation by
other than specified users.
SPLASH ID SCREEN ....IMAGE CAPTURE and SPLASH
SCREEN in the menu become unavailable. SPLASH
SCREEN will be set to ON automatically.
To enable the password function:
1. Display the FEATURE menu.
2. Press the  or  button to select PASSWORD
FUNCTION.
3. Press the  button to change the mode among
DISPLAY INPUT, MENU ACCESS, and SPLASH ID
SCREEN.
• When the password has already been set, the
mode won't be changed. In such cases, press the
ENTER button to cancel the password function
and try again.
4. Press the ENTER button.
• The screen for setting the password function will
appear.
5. Press the ENTER button.
• The screen for entering a password will appear.
6. Press the  or  button to select a number from 0
to 9.
7. Press the  button.
• You can set the next digit.
8. Repeat steps 6 and 7 to set a four-digit password.
9. Enter the password again for confirmation using the
same steps.
10. Select OK, and press the ENTER button.
• If the entered passwords don't match, an error
message will appear.
• To cancel the procedure, select CANCEL, and
press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
To cancel the password function:
1. Display the FEATURE menu.
2. Press the  or  button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for canceling the password function
will appear.
4. Press the ENTER button.
• The screen for entering the password will appear.
5. Press the  or  button to select a number from 0
to 9.
6. Press the  button.
• You can set the next digit.
7. Repeat steps 5 and 6 to enter the four-digit pass-
word.
8. Press the  button, select OK, and press the ENTER
button.
• If you enter a wrong password, an error message
will appear.
• To cancel the procedure, press the  button,
select CANCEL, and press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
Important:
• If you forget your password, keep pressing the
MENU and ENTER buttons on the control panel at
the same time about three seconds to cancel the
password function.