Installation – Miele HG01 User Manual

Page 16

Advertising
background image

Install the bracket on the rear of the
custom door panel

^ Make sure the dishwasher is level.
^ Measure the distance

X

between the

round hole in the machine outer door
panel (shown in inset) and the lower
edge of the adjoining cabinet door.

^ Place the door panel on a flat sur-

face, good side face down, being
careful not to scratch the surface.
Make certain that the bottom of the
panel is towards you.

^ Using a pencil, lightly draw a vertical

centerline on the panel (See the illus-
tration on the next page).

^ Draw a horizontal line

X

inches up

from the bottom edge of the panel.

For two piece panels:

If your two piece panel is joined to-
gether using hardware that is not flush
with the rear of the panel, this hardware
must be removed. The mounting
bracket supplied with the machine can
be used to secure both pieces to the
dishwasher.

When mounting the two pieces,
make sure that the desired finished
panel height is maintained.

Installation

16

Advertising