Miro Displays P17F98 User Manual
Page 12
T
ROUBLESHOOTING
Wrong or abnormal colors.
ü
If any colors (Red, Green, or Blue) are missing, check the video
cable to make sure it is securely connected. Loose pins in the
cable connector could cause a bad connection.
ü
Connect the miro P17F98 Monitor to another computer.
ü
Check the graphics card for proper sync scheme (or sync
polarities) to match the miro P17F98 Monitor’s specifications.
ü
Magnetic objuct nearby.
Entire screen image rolls (scrolls) vertically.
ü
Make sure the input signals are within the CRT monitor’s specified
frequency range.
(Maximum: VESA, MAC 1600 x 1200 @ 75Hz)
ü
Connect the video cable securely.
ü
Try the miro Monitor with another power source.
Image is not correctly shaped.
ü
A new video mode is selected.
ü
User control has not yet been adjusted. Use the function keys
to adjust image.
T
ROUBLESHOOTING
If your monitor is not performing properly, use the following troubleshoo-
ting for quick solutions to common problems. If the problem persists, call
the dealer. Where you purchased the monitor.
No picture.
ü
Power cord and signal cable are securely connected.
ü
Monitor in power save mode?
Display image is too large or small.
ü
Use the function keys to adjust the image.
Power on but no screen image.
ü
Make sure the video cable attached with this monitor is tightly
secured to the video output port on the back of the computer.
ü
Adjust the brightness and contrast.
Image is unstable, unfocused, scrolling.
ü
Signal cable should be completely attached to the computer.
ü
Check whether the resolution or refresh rate in windows display
setting is beyond supported range (please refer to the specification
of supported mode).
Flickering.
ü
Not enough power is being supplied to the miro P17F98 Monitor.
Connect the miro P17F98 Monitor to a different outlet. If a surge
protector is being used, there may be too many devices plugged in.
ü
See Timing Guide in this manual with a list of refresh rates and
frequency settings showing the recommended setting for the
miro P17F98 Monitor.
Double (split) screen image.
ü
Make sure your graphics card is set to Non-Interlaced mode.
14
15