Miro Displays P17F98 - Manual (Page 7)

I NSTALLATION
S WIVEL B ASE
To attach the swivel base to the monitor, do the following:
1. Carefully turn the monitor on its side or upside down. (see figure 2)
2. Locate the cavities at the bottom front of the monitor.
3. Insert the pegs on the swivel base into these cavities.
Push firmly toward the front (CRT direction) of the main unit
until the latch at the bottom of the monitor clicks shut. This
locks the swivel base into place.
4. To remove the swivel base, use your thumb to push the latch to
disconnect the latch properly, push down firmly and pull the
base against the main unit. The base removes from the
attached position.
figure 2
4 5
I NSTALLATION
Follow these steps to install the monitor
1. Switch the power off to both your monitor and computer. The
location of the power switch is on the lower right hand corner
of the monitor.
2. Connect the 15 pin signal cable to the your computer. Lock both
screws to ensure grounding.
3. Connect the female end of the power cable to the power input on the
back of the monitor. Next, plug the male cable to the wall outlet for
power. The adapter may be required for certain Apple Macintosh
computers. Tighten the two screws on the cable connector.
To power input of monitor.
figure 3
4. Switch ON the power to both your color monitor and computer.
5. The tilt-swivel base can be adjusted for your maximum viewing comfort.
figure 4
Note:
Due to the sensitivity of this monitor to earth's magnetic field, you may
experience minor irregularities in the display if you swivel the monitor through
more than 90° while the monitor is ON. If such behavior occurs, please turn
the monitor OFF and ON again. The display should return to normal.