MITSUBISHI ELECTRIC XD20A - Manual (Page 17)

E – 17
AUDIO MOUSE RGB / YCbCr VIDEO S-VIDEO
The remote control of this projector can be used as the PC mouse (wireless mouse function) by connecting the MOUSE connector of this
projector and the PC.
Remote control mouse functions
• When the MOUSE button on the remote control is pressed, the button is lit in red.
This red light shows that the cursor key on the remote control operates the computer mouse
function.
When the MOUSE button is pressed again, the button's light goes off. In this condition the cursor
key operates the projector cursor function.
• If a computer running Windows is connected, the ENTER button on the remote control operates
as the computer mouse left click button and the CANCEL button as the computer mouse right
click button.
• If a Macintosh computer is connected, the ENTER and CANCEL buttons operate in the same way as the computer mouse click button.
Connecting a PC and the MOUSE connector of this projector
Before connecting a PC
• Before connecting, turn off the PC power. Turn off the power of this projector if it is on.
• When connection is completed, turn on the power of this projector and then start the PC.
U s i n g t h e R e m o t e C o n t r o l a s t h e P C
M o u s e
IBM PC/AT or
Macintosh
USB Port Connection
Connect the supplied USB mouse cable directly to the USB
port (universal serial bus) of the personal computer, as
shown in the diagram.
IBM PS/2 Mouse Port Connection
Connect the supplied PS/2 mouse cable to the personal
computer, as shown in the diagram.
MOUSE connector
USB mouse cable (accessory)
PS/2 mouse cable (accessory)
To PS/2 MOUSE
port IBM PS/2 compatible
Personal computer
USB port
MOUSE POWER
VIDEO
MENU
CANCEL
RGB
MOUSE button
Note
• Depending on the personal computer, the mouse may not be recognized in some cases if not connected to the MOUSE connector before the personal
computer power is turned on.
• In the case of some notebook and laptop type personal computers, it may not be possible to use the standard pointing device (track ball, etc.) of the
personal computer when connected to the MOUSE connector. In such case, it will not be possible to use the pointing device until the personal
computer is rebooted, even if disconnected from the MOUSE connector.