Manual adjustment of personal computer images – MITSUBISHI ELECTRIC XD20A User Manual

Page 24

Advertising
background image

E – 24

M a n u a l A d j u s t m e n t o f P e r s o n a l
C o m p u t e r I m a g e s

Adjusting Clock Frequency and Phase

1

Select RGB as the input (page 16).

2

Press the MENU button to display the
main menu and then press the cursor

/

keys to select the “IMAGE”.

3

Press the cursor / keys to select the
“PICTURE ADJ”.

4

Press the cursor

/

keys and adjust the

image width in relation to the screen.

Adjustment is performed in dot units. Adjust to
the position where vertical flicker disappears.

5

Press the cursor / keys and select
“FINE PICTURE”.

6

Press the cursor

/

keys and adjust to

minimize image noise, flicker, color varia-
tions, etc.

Reconnecting a separate personal computer or
other device to the RGB jack

Either press the AUTO button on the main unit or open the FLIP
COVER of the remote control and press the AUTO button there.

If no images appear during setting

Use the following procedure when no images appear during setting
because the clock frequency or phase is grossly inaccurate.

1 Turn off the power of all devices connected.

The input signal will stop and either a blue or black background
(This depends on the Background setting. page 28) will be
projected.

2 Perform a reset (page 25).

3 Readjust the picture ADJ and fine picture

Adjusting the position of the image

If the image is offset up, down, left or right, adjust the
vertical and horizontal position.

1

Perform steps 1 - 6 for Adjusting the
Clock Frequency and Phase on this page.

2

Press the cursor / keys and select
“POSITION”.

3

Press the cursor / ,

/

keys and

adjust the horizontal and vertical posi-
tion.

To select other menu names

Press the MENU button. The cursor
will disappear and the menu selection
screen will be displayed.

To close the menu

Press the CANCEL button.

Advertising