Memorex MVT2195B - Manual (Page 22)

20
PO WER
SLEEP
TV MONI.
EJECT
QUICK VIEW
MUTING
INPUT SELECT
REC/O
TR
SPEED
MENU
–
+
–
+
SET/TRA
CKING
SKIP SEARCH
COUNTER
RESET
ZER
O
RETURN
AU
TO
TRA
CKING
TV/CAP/
TEXT
PR
OGRAM
CANCEL
ENTER
ST
OP
PLA
Y
F.FWD
REW
TIMER REC
PA
USE/STILL
CHANNEL
CALL
1
2
3
4
5
6
7
8
0
9
–
+
VOLUME
TV OPERATION
(CONTINUED)
Press this button to switch between normal TV and
the two closed caption modes (captions and full
screen text). Closed captioning will display text on the
screen for hearing impaired viewers.
NOTES: • If using an indoor antenna or if TV reception is very poor, the Closed Caption Decoder text may not appear.
In this case, adjust the antenna for better reception or use an outdoor antenna.
• When activating the Closed Captioned Decoder, there will be a short delay before the Closed Captioned text
appears on the screen.
• Closed Captioned TV programs can be recorded and played back on a VCR with the Closed Captioned
text intact. The Closed Captioning text will disappear during Cue, Rewind and Pause modes or if the VCR
tracking is not adjusted properly.
• Closed Captioned text is only displayed in locations where it is available.
SLEEP
CAPTION CH 1
CH 012
This button allows you to go back to the last channel
selected by pressing the QUICK VIEW button. Press
this button again to return to the last channel you
were watching.
SLEEP
120
To set the TV/VCR to turn off after a preset amount of time, press the SLEEP button on the remote control.
The clock will count down 10 minutes for each press of the SLEEP button (120, 110, ...10, 0). After the sleep
time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is
operating. To confirm the sleep timer setting, press the SLEEP button and the remaining time will be momen-
tarily displayed. To cancel the sleep timer, press the SLEEP button repeatedly until the display turns to 0.
SLEEP
TV/CAP/
TEXT QUICK VIEW
TV/CAPTION/TEXT QUICK VIEW
545A201A-E/P20-29 19*04*0, 17*11 20