Mitel Navigator 3300 ICP User Manual
Page 33
Navigator User Guide
27
To add a call on Hold to an existing conversation or conference:
1. Press
the
Addheld softkey.
2. Press the flashing line key.
Swap
To call another party when you are in an established two-party call:
1. Press
(TRANS/CONF).
2. Dial the number.
To alternate between the two parties:
• Press
the
Trade softkey.
Call Forward
Call Forward lets you redirect incoming calls to an alternate number. You can select one of the
following forwarding options:
• Always redirects all incoming calls regardless of the state of your telephone.
• B-Int redirects internal calls when your telephone is busy.
• B-Ext redirects external calls when your telephone is busy.
• NA-Int redirects internal calls after several rings if you don't answer.
• NA-Ext redirects external calls after several rings if you don't answer.
Note: For information about "I Am Here?", see Call Forward – Remote.
To program Call Forward:
1. Press (SUPERKEY).
2. Press
the
No softkey until "Call Forwarding?" appears.
3. Press
the
Yes softkey.
4. Press
the
Next softkey until the type of Call Forward appears (see above).
5. Press
the
Review softkey.
6. If a number is already programmed, press the Change softkey.
7. Press
the
Program softkey.
8. Dial the destination number.
9. If you make an error while dialing, use the
<−−− softkey to backspace and correct the
number.
10. Press the Save softkey.