Mitel Navigator 3300 ICP - Manual (Page 47)

Navigator User Guide
41
Reminder
To program a Reminder:
1. Press (SUPERKEY).
2. Press the No softkey until "Timed Reminder?" appears.
3. Press the Yes softkey.
4. Enter the time in 24-hour format.
5. Press the Save softkey.
To view, change, and/or cancel a pending Reminder:
6. Press (SUPERKEY).
7. Press the No softkey until "Timed Reminder?" appears.
8. Press the Yes softkey.
9. Do one of the following:
• To change the Reminder, press the Change softkey, enter the new time, and press the
Save softkey.
• To cancel the Reminder, press the Clear softkey.
• To exit without canceling the Reminder, press
(SUPERKEY).
To acknowledge a Reminder when your phone rings once:
• Press
the Confirm softkey.
Tag Call
Tag Call allows you to signal that you are the victim of a threatening or malicious call. Using the
tag, your system administrator or telephone company can identify the source of the call and
provide this information to appropriate personnel or authorities.
CAUTION: Tagging a non-malicious call may result in fines or other penalties.
To tag a malicious call, do one of the following:
• Press
the Tag Call feature key while the call is in progress.
See Personal Feature Keys on page 15 for instructions on programming a Tag Call key to
your phone.
• Press
(TRANS/CONF), then dial *55.
If the call was successfully tagged, the display shows "Thank You"; otherwise, the display shows
"Not Allowed".
Note: Tag Call can be used on active two-party calls only. Calls on hold and conference calls
cannot be tagged.