Mercury INSTALLATION MANUAL D7.3L D-TRONIC - Manual (Page 67)

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 67 of 90
IMPORTANT: The position of the Trim-In Limit Pin on the Bravo Three sterndrive unit
should only be changed after the boat has been properly tested. Refer to statement
at the front of this manual entitled; “Bravo Three Notice: Trim-In Limit Pin”.
IMPORTANT: To aid in installing rubber bushings, use a water and soap solution. DO
NOT use oil or grease.
16. Install trim cylinders on aft end of drive unit with hardware as shown. Coat anchor pin
threads with 2-4-C Marine Lubricant and tighten nuts until they bottom. Install
plastic caps and tighten hand tight only.
71668 71669
a
b
c c
c
d e
f
a -
Aft Anchor Pin
b -
Large l.D. Flat Washers (2)
c -
Rubber Bushings (4)
d -
Small l.D. Flat Washers (2)
e -
Locknuts (2)
f -
Plastic Caps (2)
17. Place drive unit serial number decal as described in “General Information”.