MITSUBISHI ELECTRIC PK10 - Manual (Page 24)

EN-24
1 IMAGE
HIGH BRIGHTNESS MODE................................................
.......................................Select ON for high brightness mode.
CONTRAST .............. Use to adjust the image contrast.
The contrast becomes higher as the
value increases.
BRIGHTNESS ...........Use to adjust the image brightness.
The image becomes brighter as
the value increases.
COLOR TEMP........... Use to adjust the color temperature.
COLOR......................Use to adjust the color intensity
of the image.
TINT...........................Use to adjust the color balance of
the image. The color balance
shifts to green as the value
increases and shifts to purple as
the value decreases. (Available
only when VIDEO or S-VIDEO is
chosen as the source.)
* When the TV50 (PAL, SECAM)
signal is input, TINT can’t be
adjusted.
SHARPNESS............. Use to adjust the image sharpness.
The image becomes sharp as
the value increases.
(Not available with certain signals.)
GAMMA MODE..........Select STANDARD for computer
sources. Select THEATER for
film sources. For normal use,
select AUTO. When AUTO is
selected, the appropriate gamma
mode is automatically selected
depending on the input signal
(VGA for STANDARD, THEATER
for S-VIDEO and VIDEO).
2 INSTALLATION
KEYSTONE................Use to adjust the image distortion
caused by tilting projection (±15°).
IMAGE REVERSE......Use to reverse the projected
image. Select MIRROR for rear
projection with the tabletop-mounted
projector. Select MIRROR INVERT
for front projection with the ceiling-
mounted projector.
LAMP HOUR ELAPSE...Displays the lamp’s elapsed
operating time (in hours and
minutes).