Muratec Printer/Copier/Scanner MFX-C3035 - Manual (Page 345)

Status, error and service messages 13-42
[Replenish paper]
[Replenish paper in Tray x
or select other paper tray.]
There is no paper in
the paper tray
selected for printing.
(when [Auto Tray
Switching] is set to
[OFF]) Load paper into the
specified paper tray.
[Paper Size/Type
Mismatch]
[Load the following paper in
tray x.]
[Paper : xxxxx xxxxx]
The type and size of
the paper loaded into
all of the paper trays
are different. (when
[Auto Tray Switching]
is set to [ON]) Load the specified
paper into a paper tray.
[Output Tray Full]
[Output tray full. Remove
paper from the tray.]
The output tray is full
of paper. Remove the paper from
the output tray.
[Memory Full]
[Insufficient memory
Cancel the job.]
The print data sent
from the computer has
caused the memory to
become full. Cancel the job.
[Stored Job Error]
[Stored job specification
not correct.]
[Tray x]
Tray 3/Tray 4 was
specified for printing a
stored job when Tray
3/Tray 4 is not
installed on the
machine.
When trying to print a
stored job, the
installed memory had
been changed since
the job was stored.
Install Tray 3/Tray 4, or
install the memory that
had been installed
when the job was
stored.
[Job Registration Limit
Over]
[Registered jobs reached
limit.]
[Wait for job registration to
complete.]
Copy, scan or fax
transmission
operations were
repeated while
printing or
transmissions could
not be performed. Wait a while. The error
is canceled.
Message Cause Solution