Monster Power 15 Amp - Manual (Page 20)

14
Coaxial Connections and Decora Plate Installation
In-Wall PowerCenter comes with two coaxial connections units that provide surge protection against damaging voltage
surges and spikes on incoming coax cables. If you have in-wall provisions for satellite TV, TV/cable, cable modem, etc.,
you can protect them by hooking them up through the PowerCenter’s coax connections. If your system does not have
in-wall provisions for coax connections, you can install the included decora plate instead.
A) If installing the decora plate and not one of the coax connections units, attach by aligning the holes between
the decora plate and the gold-plated grounding plate, inserting two (2) included silver screws, and turning each
clockwise until secure.
B) If installing one of the coax connections units included in your kit, locate the incoming coax cables inside
the wall and connect them to the coax connections on the backside of unit.
C) Secure the coaxial connections unit to the PowerCenter by tucking any excess wire away, aligning the holes
between the unit and the gold-plated grounding plate, inserting two included silver screws, and turning each
clockwise until fully tightened.
D) Finish the installation by attaching the decorative In-Wall PowerCenter faceplate by aligning the holes between
the faceplate and the gold-plated grounding plate, inserting the included six (6) white screws, and turning each
clockwise until fully tightened.
F-Pin with Brush
Decora Installation
Blank Decora
Installation
F-Pin Decora
Installation