MITSUBISHI ELECTRIC HC100 - Manual (Page 27)

EN-27
ENGLISH
MENU ACCESS
SVGA60
opt.
LOCK
UNLOCK
OK
OK
PASSWORD
CONFIRM
O K CANCEL
MENU ACCESS
SVGA60
opt.
LOCK
UNLOCK
OK
OK
PASSWORD
O K CANCEL
Password function
This projector is equipped with the password func-
tion that is designed for wrong operation by children
and restriction on operation by other than specified
users.
MENU ACCESS ............ All the buttons except for
the POWER button on the projector are disabled.
(The buttons on the remote control are enabled.)
You can use this mode as a measure of prevention
of wrong operation by children and restriction on
operation by other than specified users.
To enable the password function:
1. Display the FEATURE menu.
2. Press the { or } button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for setting the password function
will appear.
• When the password has already been set, the
screen for canceling the password function will
appear.
4. Press the ENTER button.
• The screen for entering a password will appear.
5. Press the
{ or } button to select a number from
0 to 9.
6. Press the % button.
• You can set the next digit.
7. Repeat steps 5 and 6 to set a four-digit password.
8. Enter the password again for confirmation using
the same steps.
9. Select OK, and press the ENTER button.
• If the entered passwords don’t match, an error
message will appear.
• To cancel the procedure, select CANCEL, and
press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
To cancel the password function:
1. Display the FEATURE menu.
2. Press the { or } button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for canceling the password function
will appear.
4. Press the ENTER button.
• The screen for entering the password will
appear.
5. Press the { or } button to select a number from
0 to 9.
6. Press the % button.
• You can set the next digit.
7. Repeat steps 5 and 6 to enter the four-digit
password.
8. Press the % button, select OK, and press the
ENTER button.
• If you enter a wrong password, an error
message will appear.
• To cancel the procedure, press the % button,
select CANCEL, and press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
Important:
• If you forget your password, keep pressing the
MENU and ENTER buttons on the control panel
at the same time about three seconds to cancel
the password function.
Advanced features